UART6_Tx Project
-----------------

This project demostrates the use of the USART6 in Async UART mode
to give an outout serial channel to be used as a debug channel.

As the TX signal is bounded to the Discovery supplies it gives
3V for the "1" level and 0V for the "0" level.
A suitable FTDI cable or level conversion is needed to connect
this line to a serial terminal.

Lines used:

  PC6: EXT2-8 : UART6-Tx to connect to FTDI RX
  GND: EXT2-9 : Reference for serial signal

To test te project a FTDI TTL-232R-3V3-AJ cable has been used.

  

